Comtrol IOLM 4-EIP - Manual (Page 18)

18 - Chapter 3. Initial Configuration IO-Link Master 4-EIP User Guide: 2000582 Rev. A
Programming the IP Address
6. Optionally, enter a device name, which displays inPortVision DX on the Main screen.
Note: The MAC address, Serial Number, and Device Status fields are automatically completed and are
status-only fields.
7. Enter the appropriate network information on the General tab.
You can configure the IO-Link Master for a static IP address or set it to DHCP.
• If you select Static for the IP Type, you must enter a valid IPv4 address. If necessary, see your Network
Administrator for a valid IP address for this IO-Link Master.
The default IP address is: 192.168.1.250.
- Enter a valid subnet mask for your network. The default Subnet Mask is: 255.255.255.0.
- Enter a valid IP gateway address for your network. The default Gateway Address is: 0.0.0.0.
• If you select DHCP, this field displays the last IP address programmed into the IO-Link Master.
Note: Rotary switch settings override the lower 3 digits (8 bits) of static IP address.
8. Click Close to exit the Properties tabs.