Programming the ip address – Comtrol IOLM 4-EIP User Manual
Page 17
IO-Link Master 4-EIP User Guide: 2000582 Rev. A
Chapter 3. Initial Configuration - 17
Programming the IP Address
3.1.3. Programming the IP Address
Use the following procedure to program the IP address into the IO-Link Master using PortVision DX.
Note: Optionally, you can use the web interface to configure or Rotary switch to configure the IP address. You
can also refer to
2.1. Setting the Rotary Switch
The Rotary switch settings override the lower 3 digits (8 bits) of the static IP address configured in
PortVision DX or the Configuration/Network page.
1.
Start PortVision DX by using the desktop icon or click PortVision DX in the Start menu.
2.
Depending on the operating system you may need to click Yes to the Do you want to allow the following
program to make changes on this computer User Account Control popup message.
3.
Click the Scan button to locate your IO-Link Master or IO-Link Masters on the network.
4.
Click the hardware types that you want to locate and click Scan.
5.
Right-click the IO-Link Master that you want to program in the Device List pane (lower) and click
Properties.
Optionally, you can double-click on the IO-Link Master to open the Properties tabs. It may take a few
moments for the next screen to open.