Comtrol IOLM 4-EIP - Manual (Page 32)

32 - Chapter 5. IO-Link Port Configuration IO-Link Master 4-EIP User Guide: 2000582 Rev. A
Editing IO-Link Settings
5.1.1. Editing IO-Link Settings
You can use this procedure to configure IO-Link characteristics for each port. The following table or help
system provides information about each option.
1. If necessary, open the IO-Link Master web interface with your web browser using the IP address or
through PortVision DX.
2. Click Configuration in the menu bar, which by default loads the IO-Link Settings page.
3. Click the EDIT button for the port that you want to configure.
4. Make appropriate selections for the IO-Link device that you will connect to that port. You can use the help
system if you require definitions or values for the options or
5.1.2. IO-Link Settings Parameters on Page
32.
5. Click the SAVE button.
6. Repeat for each port that requires configuration changes.
5.1.2. IO-Link Settings Parameters
The IO-Link Settings configuration page supports the following options.
IO-LINK SETTINGS Page
Port Name
User defined port or device description.
• Standard ASCII characters
• Max length = 80 characters
Port Mode
Default: IO-Link
Selected IO-Link Port Mode. Valid settings are:
• Reset
• IO-Link
• Digital In
• Digital Out
Invert IO
Default: False
If enabled and the Port Mode is Digital In or Digital
Out, inverts the I/O value.
0= False (Disabled - Do not invert IO)
1= True (Enabled - Invert IO)
Note: Does not affect the Auxiliary Input.
Minimum Cycle Time
Default: 4
The minimum, or fastest, cycle time that the IO-Link
device may operate at. The valid range is 4-65535 ms.