Toshiba LF470 - Manual (Page 9)

TOSHIBA
6,F8A0,8,0,2
1 i I i I
1. Product Inspection and Storage
Upon arrival of the product package, open the package and check the items contained inside.
If you do not intend to install the product soon after opening the package, store the product
and other related items in a place such as described in 1.2 below.
1.1 Product Inspection
The LF470 electromagnetic flowmeter is shipped in a cardboard container filled with
shock-absorbing materials. Open the package carefuUy and check as follows:
■ Make sure the following items are included in the package.
(1) Model LF470 Electromagnetic Flowmeter............. j
(2) Instruction Manual...............................................
1
■ Inspect the flowmeter for indications of damage that may have occurred during shipment.
■ Make sure the type and specifications of the flowmeter are in accordance with the
ordered specifications.
If you cannot find the items listed above or any problem exists, contact your nearest
Toshiba representative.
1.2 Storage
To store the LF470 flowmeter after opening the package, select a storing
place as follows and keep it under the conditions described below:
(1) Avoid places where there is direct sunlight, rain or wind.
(2) Store the product in a well-ventilated place. Avoid places of extremely high
humidity or extremely high or low temperature. The following environment is
recommended:
• Humidity range: 10 to 90% RH (no condensation)
• Storage temperature: -15 to +65° C
(3) Avoid places where vibrations or mechanical shock occur.
(4) Do not leave the converter housing cover open . Open the cover only when
you actually start wiring cables. Leaving the cover open can cause gradual
deterioration of circuit isolation.
(5) To put the flowmeter temporarily on the floor, place it carefully with something
to support it so that the flowmeter will not topple over
- 8