Toshiba IK-DP20A - Manual (Page 7)

6. Operation :
(Power On display)
TOSHIBA IK-DP20A
VERSION ***
PROTOCOL TOSHIBA-P
ADDRESS 1
COMM 4800/N/8/1
When the dome camera powers-up, the software
version, selected protocol, and other information
are displayed on the monitor.
6.1 ACCESSING THE MENU
Accessing the menu varies with the model controller being used. Several
controllers are listed below. Please refer to your model's instructions for
information on inputting commands.
JK-UC1
Input 95 using the numeric keypad.
Press the PRESET button to display the MENU screen.
KBD200/300/300V direct
Input 95 using the numeric keypad.
Hold down the PRESET button until the MENU screen is displayed.
KBD200/300/300V CM6700 mode
Input 95 using the numeric keypad.
Hold down the PRESET button until the Edit LABEL screen of CM6700 is
displayed.
Press the TILT UP/DOWN button until SET is chosen.
Press the ACK button to display the MENU screen.
MPT9500
Input 95 using the numeric keypad.
Press the PRESET SET button.
Press the F2 button to display the MENU screen.
6.2 PAN/TILT FUNCTIONS
Manual PAN
Manual Pan is controlled from a keyboard and the speed ranges from 0.1
degrees/sec to 90 degrees/sec depending on the joystick position. In turbo
mode the speed is 150 degree/sec. However, this speed is limited when
Proportional P/T is ON.