Toshiba IK-DP20A - Manual (Page 18)

To enable SCAN LIMIT STOPS:
1. Enter 95 preset to access the main menu.
2. Position the cursor ( - > ) next to PAN/TILT SETUP and press the OPEN button to
access the Pan/Tilt menu.
3. Position the cursor next to SCAN LIMIT STOPS and press the OPEN button to
move the cursor to the right.
4. Move the joystick up or down to select ON or OFF.
5. To accept the selection, press the OPEN button or to cancel the selection, press
the CLOSE button.
To set SCAN LIMIT STOPS:
1. Set SCAN LIMIT STOPS to ON and exit menu.
2. Position the camera for the LEFT LIMIT STOP.
3. Enter 92 preset. SCAN LEFT LIMIT will be displayed on screen.
4. Position the camera for the RIGHT LIMIT STOP. If the right limit stop is less than
10 degrees from the left limit stop, NOT ACCEPT will be displayed on screen.
5. Enter 93 preset. SCAN RIGHT LIMIT will be displayed on screen.
6.5.4 MANUAL LIMIT STOPS
When a Manual Limit Stop is reached during a manual Qoystick) pan, the camera will
stop. A Left Manual Limit Stop and Right Manual Limit Stop can be set. The limit
stops must be greater than 10 degrees apart.
To enable MANUAL LIMIT STOPS:
1. Enter 95 preset to access the main menu.
2. Position the cursor (^) next to PAN/TILT SETUP and press the OPEN button to
access the Pan/Tilt menu.
3. Position the cursor next to MANUAL LIMIT STOPS and press the OPEN button to
move the cursor to the right.
4. Move the joystick up or down to select ON or OFF.
5. To accept the selection, press the OPEN button or to cancel the selection, press
the CLOSE button.
To set MANUAL LIMIT STOPS:
1. Set MANUAL LIMIT STOPS to ON and exit menu.
2. Position the camera for the LEFT LIMIT STOP.
3. Enter 90 preset. MANUAL LEFT LIMIT will be displayed on screen.
4. Position the camera for the RIGHT LIMIT STOP. If the right limit stop is less than
10 degrees from the left limit stop, NOT ACCEPT will be displayed on screen.
5. Enter 91 preset. MANUAL RIGHT LIMIT will be displayed on screen.
-
17
-