Toshiba 19SL410U - Manual (Page 5)

40) ALWAYS unplug the TV to completely disconnect from
mains power, i/l/hen the TV Is turned off using the on/
off switch, it is not completely disconnected from
power and a minute amount of current is still con­
sumed,
41) During normal use, the TV may make occasional
snapping or popping sounds. This is normal, espe­
cially when the unit Is being turned on or off. If these
sounds become frequent or continuous, unplug the
power cord and contact a Toshiba Authorized Service
Provider,
42)
DANGER: RISK OF SERIOUS PERSONAL
INJURY OR DEATH!
Never strike the screen with
a sharp or heavy object.
43) • The LCD screen of this product can be damaged
by ultraviolet radiation from the sun. When
selecting a location for the television, avoid
locations where the screen may be exposed to
direct sunlight, such as in front of a window,
• Never touch, press, or place anything on the LCD
screen. These actions will damage the LCD
screen. If you need to clean the LCD screen,
follow the instructions in item 35 on page 4,
Service
44)
WARNING: /|\
RISK OF ELECTRIC SHOCK! / |
Never attempt to service the TV yourself. Opening and
removing the covers may expose you to dangerous
voltage or other hazards. Failure to follow this
WARNING may result In death or serious injury. Refer
all servicing not specified in this manual to a Toshiba
Authorized Service Provider,
45) If you have the TV serviced:
• Ask the service technician to use only replacement
parts specified by the manufacturer,
• Upon completion of service, ask the service
technician to perform routine safety checks to
determine that the TV is in safe operating condition.
Choosing a location for your LCD TV
To Display your LCD TV on the included
Pedestal Stand:
Observe the following safety precautions:
1) Read and Follow the pedestal assembly instructions
included with the pedestal,
CAUTION: Before beginning pedestal assembly,
carefully lay the front of the LCD Panel face down on a
flat, cushioned surface such as a quilt or blanket.
Leave the bottom of the unit protruding over the edge
of the surface and assemble the pedestal as indicated
below.
Note: Extreme care should always be used
when attaching the pedestal stand to avoid
damage to the LCD panel.
2) Place the TV on a sturdy, level surface that can support
the weight of the TV,
3) Be sure to secure the TV to a wall, pillar, surface, or
other Immovable structure, (ty item 25, page 4),
To Display your LCD TV using a Wall
Bracket:
If you decide to wall mount your LCD TV, always use a UL
listed wall bracket appropriate for the size and weight of
the LCD TV (ts* * page 2):
1) CAUTION: Two people are required for Installation,
2) Unplug and remove any cables and/or other compo­
nent connectors from the rear of the TV,
3) Remove the screws of the VESA Mounting Pattern
show in the next page,
CAUTION: Do not use the screws removed from the
back cover to attach the wall mount bracket to the TV,
4) Always use the screws supplied or recommended by
the wall mount manufacturer,
5) Follow the instructions provided with your wall bracket.
Before proceeding, make sure the appropriate
bracket(s) are attached to the wall and the back of the
TV as described In the Instructions provided with the
wall bracket.
6) After attaching the appropriate bracket(s) to the wall
and the back of the TV, remove the pedestal stand
from the TV as described on the following page,
7) VESA Mounting Pattern
TV Size Hole Pattern (HxV) Screw Size
19” 100x100 mm M4
24” 100 x 100 mm M4
32” 200 x 200 mm Мб
{imit in mm)
Removing the Pedestal Stand
1) Carefully lay the front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave the
stand protruding over the edge of the surface.
Note: Extreme care should always be used
when removing the pedestal stand to avoid
damage to the LCD panel.