Toshiba 19SL410U - Manual (Page 28)

Chapter 5: Setting up your TV
Viewing the digitai signai meter
You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
1 Press " q “ and open the Setup menu.
2 Highlight Installation and press (|^.
3 A new set of In.stallation menu icons will appear.
Open the Terrestrial menu, highlight Signal
Meter, and press (a^.
4 Press to select the antenna input and
digital channel whose signal you want to check.
Note:
• The physical digital channel number listed in
the Signal Meter screen may not correspond to
a virtual TV channel number. Contact your
local broadcasters to obtain the RF channel
numbers for your local digital stations.
• The signal strength does not change between
virtual channels on the same physical channel.
To close the screen and return to the
Terrestrial menu:
Highlight Done and press ( e ^.
To return to normal viewing:
Press
o ■
Setting the time zone
The Time Zone setup will allow yon to specify the
correct time zone for your region. This feature will
allow the TV status information to show the correct
time zone information page 50).
To set the time zone:
1 From the Setup menu, highlight Installation and
press A new set of lastallation menu icons
will appear.
2 Highlight Time Zone, and press
3 Press or ► to select the region, highlight Done,
and then press ( e ^.
After the time zone has been set, yon will be asked to
set the current Daylight Saving Time status.
28
To set the Daylight Saving Time status:
1 Press M or ► to select Yes or No, highlight Done,
and then press (Q).
Viewing the system status
To view the system status:
1 Pres.s and open the Setup menu.
2 Highlight Installation and pres.s ( e ^.
3 A new set of Installation menu icons will appear.
Open the System Status menu, highlight System
Information, and press (a^.
4 Press or ► to scroll through the menu bar to
select the Factory Defaults or Support
Information and view the related information.
To close the screen and return to the
Installation menu:
Highlight Done and press ( e ^.
To return to normal \iewing:
Press .
Reset Factory Defaults
To reset all settings and channels to their
factoiT default values:
1 Press and open the Setup menu.
2 Highlight Installation and press A new set of
Installation menu icons will appear.
3 Open the System Status menu, highlight System
Information, and press (Q).
4 Press or ► to scroll through the menu bar to
select Factory Defaults.
5 Highlight Yes and press { e ^.
6
(If PIN code has been set, enter your PIN code.
Press or ► to select Done and press ( e ^.) A
warning message will appear, select Yes and press
1 ^^, the TV will turn off automatically after a few
seconds. After the TV turns off, unplug the TV
power cord and then plug it in again to complete
the reset process.
To cancel the reset:
Select No and press in step 5 above.