Toshiba 19SL410U - Manual (Page 18)

Chapter 2: Connecting your TV
Connecting a digital audio system
The TV’s
DIGITAL AUDIO OUT
terminal outputs a
*Dolby^' Digital or 2-channel down-mixed PCM
(pulse-code modulation) signal for use with an
external Dolby^' Digital decoder or other external
audio system with optical audio input.
You will need:
• Optical audio cable (Use an optical audio cable that
has the larger “TosLink” connector and not the
smaller “mini-optical” connector.)
TV back panel
*1^ lllllll DUStasK”
Optical
audio
cable
j ( lllllll |tetew«w«w«i
To control the audio:
1
Turn on the TV and the digital audio device.
2
Press on the TV’s remote control and open
the
Sound
menu.
3
Highlight
Audio Setup
and press [i
In the
Optical Output Format
field, select either
Dolby Digital
or
PCM,
depending on your device
(c^ "Selecting the optical audio output format" on
page 39).
1
^—1
............................1
" "1
. . 1
18
Note:
• Some audio systems may not be compatibie
with Dolby Digital bitstream signals. Older
audio systems that are not compatibie with
standard optical out signals may not work
properly, creating a high noise level that may
damage speakers or headphones. THIS
DAMAGE IS NOT COVERED BY YOUR
WARRANTY.
• The DIGITAL AUDIO OUT terminal may not
output some digital audio sources because of
copy restrictions.
* Manufactured under license from Dolby Laboratories.
Dolby, and the double-D symbol are trademarks of
Dolby Laboratories.
Connecting a stereo audio system
With the TV’s analog stereo audio output terminals,
you can connect the TV to a stereo audio system that
is equipped with analog stereo audio input terminals.
You will need:
• One stereo RCA to RCA audio cable
TV back panel
pif .........ч ип'll' HOMI IN mriffmmmiim"frrmmi DIGITAL
1 Home AUDioou
(c ''
€
Щ Ò Ф
о
© @ © © ©
■ / IDIOO rmd
ti
stereo RCA to RCA
audio cable
Note: The audio signal from this output is
always available. However, the volume is fixed
and can only be controlled by the stereo audio
system connected.