Selecting the menu language, Programming channels into the tv’s channel memory, Initial setup – Toshiba 19SL410U User Manual
Page 24: Pres.s to close the
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Initial Setup
When yon first turn on or reset the TV, the Initial
Setup window will appear.
1
In the
Menu Language
field, press ^ or ► to
select your preferred language.
2
Press
A
or
T
to select
Time Zone Setup
and set
your desired time zone with or ► and press
3
Next, the
Location
setting window will appear.
For normal home use, press to select
Home.
4
Next,
ANT/CABLE In
setup window will appear.
Press or ► to select the input source
(Cable
or
Antenna)
for the
ANT/CABLE
input on the TV.
5
If you select
Antenna,
the
Channel Tuning Mode
setup window will appear. To tune only digital
channels, select
Digital.
To tune digital channels
preferentially over analog when entering channel
number directly, select
AutO.
For normal tuning,
select
Standard.
Press (Q) to continue to Auto
Tuning.
6
Press (Q to select
Start Scan
and continue with
the Auto Tuning.
You
can
stop
the
Initial
Setup
with
However
if
you do not finish the entire Initial Setup process, the
Initial Setup window will appear every time you turn
on the TV.
Selecting the menu language
You can choose from three different languages
(Engli.sh, French, and Spanish) for the on-screen
display of menus and messages.
To select the menu language:
1
Press and open the
Preferences
menu,
highlight
Menu Language.
2
Press or ► to select your preferred menu
language.
24
3
Pres.s to close the
Preferences
i
Configuring the antenna input
source for the ANT/CABLE terminal
To configure the ANT/CABLE input source:
1
Press *^
0
*^ and open the
Setup
menu.
2
Highlight
Installation
and press
3
(A new set of
Installation
menu icons will appear,
as shown below.) Open the
Terrestrial
menu,
highlight
Input Configuration,
and press
4
Highlight
ANT/CABLE In
and press or ► to
select the input source
(Cable
or
Antenna)
for the
ANT/CABLE
input on the TV.
5
To save your new settings, highlight
Done
and
press (Q). To revert to your original settings,
highlight
Cancel
and press (Q).
Programming channels into the
TV’s channel memory
When you press [Aj or [^| on the remote control or
TV control panel, your TV will stop only on the
channels you programmed into the TV’s channel
memory.
Follow the steps below to program channels into the
TV’s channel memory.