Toshiba 19SL410U User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 6: Using the TV's features
In
Select Mode,
when yon stop on an item in the
Channel Browser™, it will be highlighted but yon
must press to nine the TV to the highlighted
item.
2
Press (Q) to time the TV to the highlighted item.
3
Press to close the Channel Browser™.
Adding and clearing channels and
inputs in the History List
Adding channels and inputs to the History
List:
As a channel or input is timed, the Channel
Browser™ adds it to the History List and displays it
on the “right side” of the Channel Browser™.
Previously timed channels/inpnts are “shifted” to the
left, eventually moving off the left side. Press ^
to
surf backward through the previously timed channels/
inputs. Any channel or input that is timed repeatedly
will not be repeated in the History List, but instead is
moved to the end of the list on the right side of the
Channel Browser™.
The Channel Browser’^’''* will store the following
channels:
• All channels that are timed using the numeric
buttons on the remote control.
• All channels that are timed using or on the
remote control.
Note:
Whenever an item is selected that cannot
be tuned (for various reasons), the TV will
automatically tune to the previously viewed
channel or input.
Clearing channels from the History List:
• Reconfiguring the
ANT/CABLE
input will clear the
History List.
Note:
See page 24 for details on configuring the
antenna input.
•
Once 32 channels or inputs are stored in the Hi.story
List, the oldest item will be removed from the list
when a new channel or input is timed.
• Turning off the TV will clear the History List.
Setting the Channel Tuning Mode
This feature allows yon to choose how timing will be
handled for analog and digital channels when the TV
is in Antenna mode.
Note:
To use this feature, the
Input
Configuration
must be set to
Antenna
page 24).
32
The channel timing mode has three options.
Mode
Standard
Descriplion
Both analog and digital channels can be
timed normally
Auto
(default)
Digital channels will have priority when
manually entering a channel number
using the Channel Number (0-9) on the
remote control, analog channels can still
be timed by / [^, if available
Digital
Only digital channels can be tuned
To set the Channel Tuning Mode:
1
From the
Setup
menu, highlight
Installation
and
press {E^. A new set of
Installation
menu icons
will appear.
2
Open the
Terrestrial
menu, highlight
Channel
Tuning Mode,
and then press ► to select your
desired mode.
Note:
• The Channel Options windows as wei! as the
Channei Browser ANT/CABLE iist wiii be
updated automaticaiiy when you change the
mode. Aiso, the History List wiii be cleared, but
the Favorites List will be saved.
• Even if the Channei Tuning Mode is set to
Digital,
analog channei 3 remains the default
channel in the event no digital channels were
found in prior channel scans. (Channel Options
will not have anything listed until a scan is
done.)
Tuning to the next programmed
channel
To tune to the next programmed channel:
Press [y| or [yj on the remote control or TV control
panel.
Note:
This feature will not work unless you
program channels into the TV’s channel memory
("
is
*
page 24).
Tuning to a specific channel
(programmed or unprogrammed)
Tuning analog channels:
Press the Channel Number (0-9) on the remote
control. For example, to select channel 125, press 1,
2, 5, then (ft.
Tuning digital channels: