Rca dss^ satellite receiver, Position rca dss® receiver, A. basic hookup – RCA VR725HF User Manual
Page 8: Connect as shown, Plug in power cords of vcr, tv, and receiver, Hooking up the vcr
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hooking Up the VCR
RCA DSS^ Satellite Receiver
Position RCA DSS® receiver.
Position the receiver on top of the VCR. You
may need to position it at different angles
before the VCR can control it. Make sure the
receiver does not cover the transmitting
window on top of the VCR.
Transmitters
A. Basic hookup.
Use this hookup if your TV does not have
audio/video jacks.
1. Set the CH3 CH4 switch on back of
satellite receiver to either channel 3 or 4.
You will tune the VCR to this channel or its line
input (LI) to record from the receiver.
To watch the satellite receiver, turn off the VCR.
If you want to watch or record the signal from
your antenna, cable, or cable box, make sure the
satellite receiver is turned off.
2. Set the CHS CH4 switch on back of VCR
to either channel 3 or 4.
You will tune the TV to this channel and use the
TV»VCR button to watch the VCR.
3. Connect as shown.
This connection may require additional
accessories not provided.
4. Plug in power cords of VCR, TV, and
receiver.
Continue to page 10.
Caution: The unauthorized recording
of satellite broadcasts, television
programs, or other materials may
infringe the rights of others.
□
From
Cable, Cable Box
or Antenna
Back of Satellite Receiver
75 to 75/300 Ohm
Separator