Toshiba TEC FDS-30 - Manual (Page 74)

EOl-11032
4. READ (X) AND RESET (Z) REPORTS
The following table shows the key operation to take each report. The “X” and “Z” reports have
exactly the same print content if both are available, except that:
1. The “X” reports allow to read the sales data but not clear memories, while the “Z” reports
allow to read the sales data and at the same time all the resettable memories will be
cleared when the reports have been issued.
2. The symbol “Xnn" is printed on the top line of an “X” report, while “Znn” is printed on a
“Z” report, (“nn“ is the Report No.)
3. A reset count is printed on the bottom of a “Z” report only.
TABLE OF OPERATIONS FOR X AND Z REPORTS
Daily Reports (GT Lock; Neutral Position)
№(>OnT
HEADEH :
........... .........
K6V wawvTiow
X03
Z03
FINANCIAL READ AND RESET
• Financial Read
• Financial Reset
X
z
j 3 lAT/TLl (Drawer opens.} 14
X04
Z04
CASHIER READ AND RESET
• Individual Cashier Read
• Individual Cashier Reset
X
z
With CASHIER SIGNING Method:
1 Cashier ID Code 1 TLOGI
{2-digit manager-assign code)
With CASHIER KEY Method:
Set the Cashier Key of the required
cashier. 4 [AT/TLl.
(Drawer opens.)
17
X05
205
SALESPERSON READ AND
RESET
• All Salesperson Read
• All Salesperson Reset
X
2
] 5 [AT/TLJ 18
X06 CREDIT CARD COMPANY
SALES READ
X 6 lAT/TL] 18
X07 DEPARTMENT GROSS
PROFIT READ
X 7 [AT/TLl 19
X08 DEPARTMENT GROUP READ X 8 [AT/TLl 19
X09 MEDIA SALES AND IN-
DRAtWER TOTAL READ
X 9 [AT/TL] (Drawer opens.) 20
X10
210
HOURLY RANGE READ AND
RESET
• Hourly Read
• Hourly Reset
X
2
] 10 [AT/TLl 20
-- To be continued
- 8 -