Toshiba TEC FDS-30 - Manual (Page 102)

E01-11032
STORE NAME /MESSAGE AND COMMERCIAL MESSAGE
PROGRAMMING OR CHANGING (Submode No. 1)
j^[X]------ i------p. |Une No.| [ST]
1 to3
Submode No.
U07
(See NOTE 2
(For sequentially
programming lines, the
line number specification
cEui be sKipp^.)
Character Entries
rriax. 20 characters/line
(See page 30)
tST]
Repeat for
another line.
^ [AT/TL]
To complete
this line
To complete
this
programming
operation
NOTES 1. For each line, a maximum of 20 regular-sized characters or 10 double-sized
characters may be entered. A combination of both types is also available.
2. If the option “S/ore Name Print by RUBBER STAMP” is selected, no data can be
programmed for the store name/message. Therefore, enter 1 to 3 as Line No. for the
commercial message data only.
If the option "Store Name Print by DOT PRINTER” is selected, use 1 through 4 for the
store name/message and 5 through 7 for the commercial message data, as Line No.
3. If no commercial message is required on the receipt, program blanks for all three lines.
As a result no extra lines will be fed. If any one of the three lines is programmed, the
two other lines will cause tine feeds.
4. The 4-line range assigned for the store name/message will be either printed or fed,
regardless of any system option selection.
5. If any incorrect characiers have been programmée/, depress the [C] key to clear all
the charaefers on a line and then re-enfer characters from the beginning, or end the
line with an [ST] and re-program the entire line. The new data will be active.
6. When all the lines have been programmée/, do a check by issuing a receipt. Only the
lines with errors need to be re-programmed; other lines will not be affected.
- 3 6 -