Toshiba TEC FDS-30 - Manual (Page 122)

EO-11032
PLU PRESET-CODE KEY SETTING (Submode No.27)
When there are any keys programmed as PLU Preset-code Keys on the ECR Keyboard, and/or when
the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may be preset to
each of those keys in this operation.
Any time outside a sale
Mode Lock : SET / GT Lock : Neutral
27 [@/FORl
Repeatable for other keys.
1 PLU Code I
Enter through Numeric
Keys on the ECR
Keyboard (Enter 0 to
close Uie key)
[KEY] ----
Depress the required
key on the ECR
Keyboard or on the PK-
2 Keyboard.
-> [AT/TL]
NOTES : 7. If the PLU Code entry is skipped and a [KEY] is simply depressed in the
above sequence, the preprogrammed PLU Code of the KEY will be
displayed.
2. A non-opened PLU Code (i.e. PLU non-existent in the PLU table file) can be
set on a KEY; however, pressing the KEY in sale entries will result in an
error
unless the code is opened in the PLU TABLE PROGRAMMING
operation. Submode No.4.
3. If “0” is entered as PLU Code in the above sequence, the KEY will be
closed. Pressing the closed KEY in sale entry will not be processed.
ex) To set the following PLU Codes to the following KEYs on the ECR keyboard and/or
on the PLU Keyboard respectively :
PLU Code
Mode Lock to SET.
27 [@/FOR]
{Enter through (Depress the required
Numeric Keys on KEY on ECR or PLU
ECR Keyboard) Keyboard)
3
5
[AT/TL]
Location Code (left side); refer to REMARKS 1
and 2 on the next page.
PLU Code assign^ to the key (right side)
[required key]
[required key]
THC store ;
1343 PEACH DRIVE
PHONE: 87-6437
Thank you
Call again
phone : 87-6437
09-21-90 ttO
F-a?
»053 0003
«037 0005
0057 13:27TM
- 56 -