Department listing capacity setting (submode no.8), Department listing capacity setting – Toshiba TEC FDS-30 User Manual
Page 115
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOI-11032
DEPARTMENT LISTING CAPACITY SETTING (Submode No.8)
The LC (Listing Capacity) setting is used to check an amount limit error. By setting the LC, an
amount entry (due perhaps to a mistake by the operator) will be prevented at the earliest stage (i.e.
an error will result on entering an excessive amount through the department key).
Any time outside a sate
Mode Lock :
SET
/
GT
Lock : Neutral
8 [@/FORl
-► I
HALC
I I
LALC 1
I_____________
LC for the individual
dept
( [SHIFT]) -►[DEPT]
for the
shifted
depts.
■► I
HALC
I
I
LALC !
[AT/TL]
Common LC for all
depts
Repeatable for other departments
* HALC .... High Amount Listing Capacity (to be set in a 2-diglt code.)
ex.)
I
3
I 1
4
1
______ indicate $39.99 .... equal to or smaller than $39.99
A 4
— 4 digits
Value of the top
digit
LALC ...... Low Amount Listing Capacity (to be set in a 2-digit code.)
ex.)
I
2 i 1 2
I
- indicates $0.^ .... larger than $0.29
— 2 digits
Value of the top
digit
ex.) To set the following LCs.
Individual LCs (HALC $39.99, LALC $0.29) for Dept. 3.
Common LCs (HALC $99.99, LALC $0.19).
Mode Lock to
SET,
enter
8,
depress
[@/FOR],
3422
[DEPT 3]
9412
[AT/TL],
NOTES : 1. If the individual LC of a department is set, it
prevails over the
common
listing capacity.
2. To reset a listing capacity, enter 00 before the
[DEPT] key or the [AT/TL] key in the above
operation.
TEIC
STORE
1343 PEACH DRIVE
PHONE: 87-6437
ThanK you
Ca1L again
PHONE! 87-6437
09-21-90
ffO
POS
03 SALAD
3422
9412
0040 ll:00TM
-
49 -