5 replacing the ribbon cartridge, 6 replenishing the store name stamp with ink – Toshiba TEC FDS-30 User Manual

Page 60

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

E01-11032

Fig-2

14.5 REPLACING THE RIBBON

CARTRIDGE

When the receipt and journal print is too tight, replace the

Ribbon Cartridge in the following manner:

1. Remove the Ribbon Cover (Fig. 1).

Remove the old Ribbon Cartridge by pulling it toward

you (Fig. 2).

Install a new Ribbon Cartridge in the reverse order to

Step 2 above (Fig. 3).

The Ribbon Cartridge is a consumable product. Be

certain to use a genuine Ribbon Cartridge supplied by
your TEC representative,

14.6 REPLENISHING THE STORE

NAME STAMP WITH INK

When the store name stamp is printed too lightly,

replenish the ink in the following manner:

1. Turn the Power Switch to OFF.

Cover-

Remove the Paper

Withdraw the store name stamp with the protruding

part pinched between your fingers (Fig. 4).

Apply ink to the pad on the rear side of the Store

Name Stamp. The amount applied should be

adjusted according to the desired darkness of the

printed message, but the limit of 2 cc should not be
exceeded. (The ink bottle supplied contains 5 cc of
ink.) (Fig. 5)

Fig. 3

4. Follow the reverse order of the instructions in Step 2,

and then attach the cover.

Store Name Stamp

ink

Fig. 4

-54-