System option setting, Programming procedure – Toshiba TEC MA-305-100 User Manual
Page 95
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11068
19. System Option Setting
This chapter is provided for your selections of the register’s basic functions
according to the market and your requirements, some of which are already
indicated for reference in other chapters as to print/non-print items, key
functions, etc.
Programming Procedure
The System Options are divided into 12 addresses (Addresses 1 to 16; Addresses 4, 5, 9 and
10 are vacant) and each address is further divided into a maximum of 8 bits (Bits 1 to 8).
Each Address table is placed on the following pages.
Condition:
After Daily Financial Reset
(refer to “NOTE on Condition” on page 22)
Programming Procedure:
Use the
MA Key
to turn the
Control Lock to
“SET"
or the
S Key
to turn the Gontrot bock to:
“BblND”
.
Enter a maximum of eight-digit number composed of Bit Nos. whose status must be
set to the “SET” status in the Address. If there is no Bit Nos. to be set to the
“SET” status, enter “0” for the Address.
Examples) To SET Bit 2 only ................................................. Enter 2.
To SET Bits 2 and 3 .......................................... Enter 23.
To SET alt the Bits............................................. Enter 12345678.
To RESET all the Bits ....................................... Enter 0.
To change any Bit in an Address, enter the Address No. and enter all the SET Bit
Nos again. If a Bit No. is not included in the SET Bit Nos, the Bit will be RESET.
- 9 3 -