Toshiba TEC MA-305-100 - Manual (Page 48)

EO1-11068
PLU (Price-Look-Up) PLU
I
(PLU Key)
A “PLU” is an individual merchandise item programmed with its own item code (PLU Code), its
link department (and mostly with a Preset Price). By programming PLUS, you can enter an
individual item by entering its PLU Code (which should be written on the price tag of the item),
instead of entering the price through a Department Key. By taking PLUs Reports, you can
analyze the sales data of each individual item. A maximum of 200 PLUs can be programmed.
Programming PLUs
Programming PLU Table:
Condition: To change settings of a PLU: When the required PLU sales total memory is
zero (i.e. when no sales are made or after a PLU Reset Report is taken to
reset the sales data of the PLU into zero)
To add new PLUs: Any time outside a sale and signed off.
(refer to ‘'NOTE on Condition'’ on page 22)
Programming Procedure:
....... -...... Use the MA Key to turn the...................................................
Control Lock to “SET”.
NOTES 1.
2 .
3.
4 .
When sequentially programming the PLUs, the code specification can be
omitted. When it is omitted at the very first PLU, PLU Code “V* is
automatically assigned.
An Open-price PLU always requires a price entry through Numeric Keys in
sale entries, and may be used for an item that frequently changes its price.
The Department Key must not be an Other Income Department. If an Other
Income Department Key is depressed, no error occurs here but will occur on
entering the PLU in sale entries.
The statuses (Positive/Negative Status, Tax (PST) 1 & 2 Status, GST Status,
and Key Type Status except Other Income) of each PLU is decided by the
statuses of the Department to which the PLU is linked.
- 4 6 -