Tax table setting, Condition for setting: after daily financial reset, Setting procedure – Toshiba TEC MA-305-100 User Manual
Page 24: Go to 1), 2), or 3) on the following pages
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11068
13. Tax Table Setting
For details about the actual tax table, contact to the location where the register
was purchased.
Setting the U.S. Tax Tables (also applicable to PST in Canada)
There are three ways to set state and local tax tables. Select one that suits
the tax table required to be set.
Condition for Setting: After Daily Financial Reset
NOTE on "Condition’*:
Unless the register satisPes this condition, the programming operations will not he
allowed.
“After ... Reset” means that the designated reset report must be taken before
entering the programming (setting) operation. An error will result if the operation is
attempted without taking the report.
However, it does not necessarily mean “immediately after...” When the designated
reset report has already been taken and then some operations are performed in the
“X”, “2”, or “SET” mode, the condition “After ... Reset” is still satisfied and the
programming operation is still allowed.
On the contrary, when the designated reset report has been taken hut then some
sales data relating to that report’s output data are entered in the “REG” mode, the
prograrnming operation will no longer be allowed and the same reset report must be
taken again.
Thus the condition “After ... Reset” indicates that all the sales data relating to the
report data must be zero (except non-resettable memory data). Because of this
“Condition” requirement, the report data will be protected from any inconsistencies
of sales data entered in the period from a resetting of the report to another resetting
of the same report next time. When no condition is specified to a programming
(setting) operation, it means that the operation is allowed any time outside a sale but
the cashier must be signed off.
Setting Procedure:
Use the MA Key to turn the
Control Lock to “SET”.
REG
OFF
SET
—^
Go to 1), 2), or 3) on the following pages.
Indications of types of keys on the k)llowing pages:
□
...... Individual Numeric Key
I______ I ........ Data to be entered through Numeric Keys
□ ..................... Function Key
- 22 -