Read and reset reports, Programming operations relating to reports, Programming hourly range table – Toshiba TEC MA-305-100 User Manual
Page 80
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11068
18. Read and Reset Reports
This chapter describes the operation to take each report and its contents. The
report function is one of the most beneficial features of this register. As sales
data are entered, the register processes the data into appropriate totals and
counters in the report memory. The reports are not only a form of sales data
records but will also be a valuable guide to a more prosperous future of your
store if you fully utilize and analyze them.
Programming Operations Relating to Reports
Programming Hourly Range Table
The “Hourly Sales Report” is available as part of the report function. Hoiwever, sales data
entered in REG mode are processed into Hourly Ranges only after programming an Hourly
Range Table. If you have started operations on the register without this programming
operation performed, the “Hourly Sales Report” cannot take. The Hourly Sales Report table
must be programmed in order to obtain Hourly Sales Reports during operations.
Condition: After Hourly Sales Reset
(refer to “NOTE on Condition'' on page 22)
Programming Procedure:
Use the MA Key to turn the
Control Lock to “SET”.
Enter the time that ends the Hourly
Range, in the 24-hour system using
the military time. (The time to start is
the time entered for the preceding
Hourly Range.)
(See
NOTES 2, 3)
NOTES 1. A maximum of 24 hourly ranges may be set
2. Do not set an hourly range across 24:00, such as “from 23:00 to 1:00”. Such
setting does not cause an error in programming but the sales data will not be
processed into that hourly range.
-
78 -