Toshiba TEC MA-305-100 - Manual (Page 25)

EOI'11068
1) Tax 1; Full Breaks (Non-cvciic Breaks + Cyclic Breaks)
[max, amount non-taxable| —► | txi / m
[max, amount for 1C tax levied|
[max, amount for 2
TXl/M
TXI/M
i Repeat up to the “A” Break.
[max, amount for Ng tax levied] -
' ........ “A*’Break
(to indicate the “A*’ Break entry)
[max, amount for N +1 a tax levied] —*
[max, amount for N + 2& tax levied] —►
Non-cyclic
Tax Breaks
Repeat up to the “B” Break.
TXI/M I
(*‘B" Break - “A” Break
= a multiple of $1.00)
*B" Break]
a T jtu I -fto complete this tax table sef^7
Cyclic
Tax Breaks
NOTE: Each amount (break) entry may be a maximum of 4-digit value (99990).
2) Tax 1: “A” Break and % Rate Combination (Non-cvclic Breaks + % Rate)
First, set all the non-cyclic breaks up to the “A” Break entry and the [ST] key
depression shown in the above case of “1) Tax 1 Full Breaks”.
i
[Tax Rate applied when exceeding the “A” Break amount]
{Max. 6 digits up to 99.9999%. Use the [. ] key for a decimal value. Examples: To
set 5%, enter 5. To set 5.26%, enter 5->[ . ]->2->6. The fraction of the amount
resulting from this % rate calculation will be rounded off.)
I
I
(to complete this tax table setting)
3) Tax 1: % Rate Only
TXI/M I (to indicate that no breaks are entered) 0
[Tax Rate applied to any amount] —► I at /TL
(The description for the Tax Rate in the above case 2) is also applied to this case.)
- 2 3 -