Programming department lcs (listing capacities), 3ll®/for – Toshiba TEC MA-305-100 User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
E01-11068
Department Status Program Receipt Format:
Key Operation
Control Lock: SET
[3ll®/FOR|
Thank you
Call again
iKev Tvoe Status i
n 0:
Itemized >
! 1:
Single-item i
! 4:
Other Income <
i
Single-item «
L___
& Other Income'
¡Tax Status fPST)
1 0:
Non-taxable
1 1:
Tax 1 Taxable
1 ^
Tax 2 Taxable
Both Tax 1 &
i_ - _
Tax 2 Taxable
Positive/Neoative
Status
)
Blank: Positive i
- : Negative j
^GST Status
FS:
GST Taxable
Blank:
_GST
Noh-^able
Programming Department LCs (Listing Capacities):
The LC setting is used to check an amount limit error. By setting the LC, an amount entry
(due perhaps to a mistake by the operator) will be prevented at the earliest stage (i.e. an
error will result on entering an excessive amount through the department key).
Condition:
After Daily Financial Reset
(refer to '‘NOTE on Condition*’ on page 22}
Programming Procedure:
Use the
MA Key
to turn the
Control Lock to “SET”.
X
REG
OFF
SET
As for items marked with "NOTE”, refer to the corresponding
NOTE No. on
//7©
next page for further description.
0
@/FOR
Declaration of Program
No. 8 for Department LC
programming
Repeat for setting LCs of other deparpnents.
Dept
2-digit LC code
for each department
NOTES 1, 2
AT/TL
Common 2-digit LC code
for all departments AfOTES
1, 2
ex.) 3
indicates $ 39.99
-4
digits---------
00 diait----- 1
Allows to enter equal to
or smaller than $39.99 in
sale entries.
-Value of the top digit
- 3 9 -