Toshiba TEC MA-1600-100 - Manual (Page 84)

E01-11024
Combination Reports
Multiple reports can be programmed to be issued in one operation sequence. The following are
reports programmable for combinations {max, 5 reports in one table, max. 3 tables).
Please inquire this report programming of your TEC representative.
REPORT
NO. REPORT NAME AVAILABLE MODE
3 Financial Report X, Z, GTX. GTZ
4 All Cashier Report (GT only) GTX, GTZ
5 Ail Salesperson Report X, z,
6 Credit Company Sales Report X, GTX
7 Department Gross Profit Report X, GTX
8 Department Group Report X, GTX
9 Media Sales and In-drawer Report X,
10 Hourly Range Report X.
z,
11 All Department Report X,
z,
GTX, GTZ
KEY OPERATION: Mode Lock:
GT Lock:
X for Daily Read
Z for Daily Reset
GTX for GT Read
GTZ for GTZ Reset
U [АТЯи]
Enter the Report Combination-ID No.:
None (simply depress [AT/TL]): Combination Report Table No. 1
1: Combination Report Table No. 2
2: Combination Report Table No. 3
NOTE: When the mode set for taking combination reports does not match the mode of a
report contained in the table, that report will be skipped.
If no combination reports data have been programmed, Combination Report Table
No. 1 (which is issued by depressing the [AT/TL) key alone) is aofo-presei with
Report No. 11 (All Depts) and Report 3 (Financial). It will be active as Table No. 1
content unless no data are programmed for Table No. 1.
The report output order is determined by the order profiframmec/ in each table.
The drawer will open when a coniafned report is ruled to open the drawer.
-
14
-