Toshiba TEC MA-1600-100 - Manual (Page 135)

EO-1102-1
PLU PRESET-CODE KEY SETTING (Submode No.27)
When there are any keys programmed as PLU Preset-code Keys on the ECR Keyboard, and/or when
the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may be preset to
each of those keys in this operation.
Any time outside a saie
Mode Lock : SET / GT Lock : Neutral
Repeatable for other keys.
27 i@/FOni ■> I PLU Code t
Eftler through Numeric
Keys on the ECR
Keyboard (Enter 0 to
close lbs key)
-► {KEY) ----------
Depress the required
key on the ECR
Keyboard or on the PK-
2 Keyboard,
[AT/TLl
NOTES : 1. If the PLU Cade entry is skipped and a [KEY] is simply depressed in the
above sequence, ibe preprogrammed PLU Code of the KEY wilt be
displayed.
2. A non-opened PLU Code (i.e. PLU non-existent in the PLU (able file) can be
set on a KEY; however, pressing the KEY in sale entries will result in an
error unless the code Is opened in the PLU TABLE PROGRAMMING
operation, Submode No.4.
3. If “0” is entered as PLU Code In the above sequence, the KEY wilt be
closed. Pressing the closed KEY in sale entry will not be processed.
ex) To set the following PLU Codes to the following KEYs on the ECR keyboard and/or
on the PLU Keyboard respectively :
PLU Code
3
5
Mode Lock to SET.
27 [©/FOR]
(Enter through
Numeric Keys on
ECR Keyboard)
I
3
5
lAT/TL]
(Depress the required
KEY on ECR or PLU
Keyboard)
[required key]
[required key]
Locatio[i Code (left side); refer to REMARKS 1
and 2 on the no!(t page.
PLU Code assigned to the key (rigtit side)
T E C S T O R E
1343 PEACH DRIVE
PHOHE: 87-6437
Thank rou
call again
11“20”90 #3001
#001 0003
#002 0005
0104 l3i00TM
- 65 -