Toshiba TEC MA-1600-100 - Manual (Page 111)

E01-11024
STORE NAME /MESSAGE AND COMMERCIAL MESSAGE
PROGRAMMING OR CHANGING (Submode No. 1)
Mode Lock; SET / 6T Lock: Neutral
j [@/FOR]
Repeat for other line.
Submode No,
Une No. I [STl ------------------------
1 lo3
(See NOTE 2 below.)
1 to 7
“► Character Entries
(Max. 20 characters for each
line; see CHARACTER
ENTRIES, on page35.)
[STI -► [AT/TL]
Indicates the end of a line,
(Any unprogrammed parte of a fine end wiill tio
Kited with blanks.)
For sequentially programming tines, the line number spscilication can be skipped.
WOTES; i. For each line, a maximum of 20 reguiar-sized characters or 10 double-sized
characters may be entered. A comtH/iaiioir of boih types is also available.
2. If the option "Store Name Print by RUBBER STAMP" is selected, no data can he
programmed for the store oarrje/messaste. Therefore, enler 1 to 3 as Line No.
for the commercial message data only.
If the option “Store Name Print by DOT PRINTER" is selected, use 1 through 4
for the store name/message and 5 through 7 for the commercial message data,
as Line No.
3. ff no commercial message is required on the receipt, program blanks for atl three
lines. As a result no extra lines will be fed. If any one of the three lines is
programmed, the two other lines wilt cause line feeds.
4. The 4-line range assigned for the store nameimessage wilt be either printed or
fed, as long as the option "Store Name print by DOT PRINTER" is selected.
5. If any incorrect characters have been programmed, depress the [C] key to clear
atl the characters on a line and then re-enter characters from the beginning, or
end the tine wHh an [STJ and re-program the entire line. The new data will be
active.
6. When atl the lines have been programmed, do a check by issuing a receipt.
Only the lines with errors need to be re-programmed; other lines wilt not be
affected.
-
41
-