Toshiba TEC MA-1600-100 - Manual (Page 125)

£01-1102't
DEPARTMENT LISTING CAPACITY SETTING (Submode No.8)
The LC (Listing Capacity) setting is used to check an amount limit error. By setting the LC, an
amount entry (due perhaps to a mistake by the operator) will be prevented at the earliest stage (i.e.
an error wili resuit on entering an excessive amount through the department key).
^ Any time outside a sale
Mode Lock : SET / GT Lock : Neutral
8 [@/FOR]- I HALO I I LALC I
I_____________
LC for the individual
dept
( [SHIFT]) -►[DEPT]
for the
shifted
depts.
I HALC I I LALC
J
[AT/TL]
Common LC for ail
depts
Repeatable for other departments
‘ HALC . . . . High Amount Listing Capacity (to be set in a 2-digit code.)
ex.) I 3 [ I 4 i _______ indicate $39.99
1 ^ ^
------- 4 digits —
equal to or smaller than $39.99
Value of the top
digit
LALC ............ Low Amount Listing Capacity (to be set in a 2-digit code.)
ex.) I 2 I I 2 1
1
indicates $0.29 larger than $0.29
' 2 digits
Value of the top
digit
ex.) To set the following LCs.
Individual LCs (HALC $39.99, LALC $0.29) for Dept. 3.
Common LCs (HALC $99.99, LALC $0.19).
Mode Lock to SET, enter 8, depress [@/FOR],
3422 [DEPT 3] 9412 [AT/TL].
WOTES : 1. If the individual LC of a department is set, H
prevails over the common listing capacity.
2. To reset a listing capacity, enter 00 before the
[DEPTJ key or the [ATITLJ key in the above
operation.
T E C S T O R E
1343 PEACH DRIVE
PHONE! 87-6437
Thank you
C a l l again
11-20-90 «0
Poe
03 MEAT 3422
9412
0034 10:59TM
- 55 -