Toshiba TEC MA-1600-100 - Manual (Page 59)

E01-11024
10. POWER FAILURE PROCESS
if a power failure occurs, the sales memory is protected by tfie back-up battery; registration and
printing wilt normally be performed on regaining the power. However, please note the following cases:
(1) The printer will work to print the entered data without failure after the power recovery if any data
was being printed. However, one extra line may be fed on the power recovery depending on the
power failure timing.
(2) The following are displayed indications on the power recovery :
ECR CONDITION at the time of Power Failure
DISPLAY INDICATION on
the Power Recovery
OUTSIDE A
SALE.
No Key-in has been operated.
Displays zero. Opera lions may
QO on.
Numeric or Declaration Keys (such as [RTN
MDSE], [PR OPEN], etc) have been entered
but not motorized keys.
Displays "FAIL". Depress [C)
to clear the error oondiUon. and
re-start the operation from tfic
numerti; or declaration key entry.
DURING A
SALE.
No Numeric or Declaration keys have been
entered. Regains tlio display content that
was obtained just before the
power lailuro, Tfic operations
may be cuntirmed.
Numeric or Declaration keys have been
entered.
Displays “FAIL”. Depress [C]
to dear ttie ettor oondilion, and
re-sfart ihe oporaticn from Itie
numeric or declaration l(cy entry.
If a power failure occurs, it is recommended to check the receipt print content before the receipt
is handed to the customer.
11. JOURNAL AND RECEIPT PAPER-END DETECTOR
(1) This detects when either the journal or receipt paper is running out. It is provided to prompt the
operator to replace the old paper roll with a new one.
(2) When the paper roll is running out (or the paper has not been set properly), no key operation is
accepted and the AMOUNT portion of the display keeps flickering.
(3) When a new paper roll is set, only the |RF1 and [JF] keys are allowed to operate. Next, when
the [C] key is depressed, the display flickerihg will be cleared and normal key-in operations will
be accepted. When any printing has been suspended, it will continue printing.
(4) If this detector senses a paper-end condition during printing, the printing stops after the current
line printing is completed.
(5) If the [C] key is depressed in the paper-end condition, it is ignored. 7 he [C] key depression will
clear the display flickering only after the new paper roll is set.
- 51