RCA P46728 - Manual (Page 51)

Can’t select certain channel
j • Channel may not be in Channel Memory. Try pressing number buttons.
• If using VCR, check to make sure TVA^Ci? switch on VCR is in correct
position.
; • To select cable channels 100 thru 128, press number button 1 until 1­
1 appears. Then press other two number buttons. CABL£Z4/R function must
be in
CABLE
mode to select channels higher than 69.
• Channel may be locked-out with Parental Control feature. '
Noisy stereo reception
1 • May be a weak station. Change
STEREO/SAP
function to
MONO
setting
1 instead of STEREO.
No picture, no sound but power light
is on
• Maybe someone changed CABLE/AIR function to wrong position.
• Maybe a vacant channel is tuned.
• For Channels 90, 91, and 92, make sure the component connected to those
INPUT
jacks is turned on in order to see the picture.
• If watching VCR (connected only through antenna input), make sure TV is
tuned to channel 3 or 4-same as CH3/CH4 switch on VCR. Also check to
make sure TV/VCR switch on VCR is in correct position.
Sound okay, picture poor
-
■
• Check antenna coimections.
• Try adjusting SHARPNESS function to improve weak signals.
Picture okay, sound poor
■ i
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
• Try another channel.
• Try adjusting VOLUME, BASS, and TREBLE controls.
• If station is sending stereo, try changing STEREO/SAP function to MONO
setting for clearer sound.
• Try adjusting controls to turn 5R5(#) off or on.
No stereo on known stereo station |
----------- --------------------------- ^____________
• Make sure STEREO/SAP function is in STEREO mode.
Can’t get two channels in Pix-in-Pix j
!
i
• If using the
VCRl
or
VCR2»LD
button, make sure it is programmed to select
the proper video input channel as described on page 26.
• If using an S-VHS component, make sure its regular VIDEO cable is
connected to INPUT 1 VIDEO jack on the TV.
• If using a VCR, make sure the AUDIO and VIDEO OUT jacks on the VCR
are connected to the TV’s AUDIO and VIDEO /V jacks.
No picture while using Pix-in-Pix,
with S-VHS VCR or camcorder |
' 1
• If you have an S-VHS VCR (or camcorder) coiuiected, you must also
connect a cable from the VCR’s VIDEO OUT jack to the TV’s corresponding
VTDf'O/V jack in addition to the S-VHS cable.
Small picture does not have color. |
1
• The small picture will not have color if the large picture signal does not have
the color burst reference. All color signals and some black-and-white signals
are sent with color burst information. Try changing channels of the large
picture.
Remote no longer controls cable box, 1
VCR or audio equipment
• Tiy not to press any buttons on the remote while changing its batteries. You
may have to reprogram the proper code into the remote.
49