RCA P46728 - Manual (Page 50)

Troubles sometimes are caused by simple “faults” that you can
easUy correct without the help of a service technician by first
checking a few basic remedies.
Before you call or take your unit to an Authorized RCA TV
Servicenter, look below for the type of trouble you are
experiencing. Then perform the simple checks and adjustments
listed for that trouble.
If your unit is still in warranty, these checks and adjustments
could save you time aud the cost of an unneeded trip to the
servicer. They also could save you the cost of a diagnosis not
covered by your warranty.
If your unit is out of warranty, these checks and adjustments
could save you the cost of an unneeded diagnosis. If service
should be necessary, the warranty explains how to get it.
TV will not turn on
• Check to make sure TV is plugged in. ^
• Check the wall receptacle (or extension cord) to make sure it is live by
plugging in something else. .
• Maybe batteries in remote control are “dead”. Try replacing battenes.
• Maybe remote is not aimed at remote sensor. Press
POWER
button on TV.
• Make sure power cord is fully inserted into back of TV.
Controls don’t work
■
• If using remote control, make sure remote is in “TV Mode” by first pressing
the TV button. .
• Try unplugging set for two minutes and then turning it on again.
• Make sure power cord is fully inserted into back of TV.
Intermittent or no remote
• Maybe something is between the remote and the remote sensor.
• Maybe the remote is not aimed directly at the component (TV or VCR) you
are trying to control.
• Maybe remote is not in “TV Mode”. Press the TV button so remote will
control TV. • U •
• Maybe batteries in remote are weak or dead. Try replacmg battenes.
• Maybe batteries are installed incorrectly. Try replacing batteries correctly.
• Remove batteries and hold down one or more buttons for several seconds.
Re-install the batteries and try remote again.
Turns off while playing
• 5 L££P r/MER function may have been activated.
• alarm OFF function may have been activated.
• Electronic protection circuit may have been activated because of a power
surge. Wait 30 seconds and then turn bn again. If this happens fi-equently,
the voltage in your house may be abnormally high.
• Make sure power cord is fully inserted into back of TV.
Turns on unexpectedly
• ALARM OV function may have been activated.
Alarm does not turn off TV at
correct time
• Check ALARM OV/OFF function. Must be set to ON.
• Check to make sure CLOCK function is set to the correct time.
Blank Screen
• Maybe Channel 90,91, or 92 selected, but device connected to those
LVRL/T’jacks is not turned on.
• Try another chaimel.
No sound, picture okay
• Maybe sound is muted. Try pressing VOL up button to restore sound.
. Maybe TV’s speakers are turned off. Check
SPEAKERS ON/OFF
function.
• Check position of SPEAKER switch on back of TV.
continued on next page
48