Kenwood 1080VR - Manual (Page 9)

Setting up the system
lOaOVR {En/K)
Connecting audio components
Make connections as shown below.
When connecting the related system components, be sure
to also refer to the instruction manuals supplied with the
components you are connecting.
Do not connect the power cord to a wall outlet until all
connections are completed.
Microcomputer malfunction
If operation is not possible or an erroneous display appears, even
though all connections have been made properly, reset the
microcomputer referring to "In case of difficulty".
SYSTEM CONTROL jacks
For SYSTEM CONTROL connections to
KENWOOD components
-.jL
SYSTEM CONTROL
i
SLTB 3 (SH
SL16 XS 8
SYSTEM CONTROL
cord
SYSTEM CONTROL
switch
To AC wall outlet
AC outlets
I AUDIO I
IDI
i
SIGNAL
, GND
L
TAPE/MO
REC PLAY
OUT IN
ADAPTOR
OUT IN
mm,
I
Record player
l>
Caution regarding placement
(except for U.S.A. and Canada)
To maintain proper ventilation, be sure to
leave a space around the unit (from the
largest outer dimensions, including pro­
jections) equal to, or greater than shown
below:
Left and right panels: 10 cm, Rear panel: 10
cm. Top panel: 50 cm
OUT
Graphic equalizer
PLAY
REC
Cassette deck or
MD recorder
CD player
Connect at Coras firmly Loose connections may prevent proper sound transmission or produce noise.
Be sure to remove the power cord from the AC outlet before plugging or unplugging any connection cords. Plugging / unplugging connection
ccras without oisconnecting the power cord can cause malfunctions and may damage the unit.
Do hot connect power cords from components whose power consumption is ia'rger than what is indicated on the AC outlet at the rear of