Kenwood 1080VR - Manual (Page 36)

Getting the most from your remote control
Setup code correlation
108GVR (En/K)
Keys or controls used in this ooeration.
43
Deleting a setup code
O Hold down the ENT key until the backlight flashes twice.
G Select the component to be deleted.
Press the VIDEO, AUDIO, or TV key repeatedly to select the
desired component.
0 Enter the 3 digit code "991".
O Hold down the ENT key until the backlight flashes twice.
>At this time all inputs become available regardless of any earlier
registration.
• Example 1 : To delete the registration of the component connected to
the VIDEO 1 jacks, select "VIDEO 1".
Perform each step within 5 seconds.
Checking a setup code
O Hold down the ENT key until the backlight flashes twice.
G Select the component with setup code you want to check.
Press the VIDEO, AUDIO, or TV key repeatedly to select the
desired component.
G Enter the 3 digit code "990".
O Press the 1 key and count the number of times the backlight
blinks. This is the first number of the 4 digit setup code.
O Press the 2 key and count the number of times the backlight
blinks. This is the second number of the 4 digit setup code.
G Press the 3 key and count the number of times the backlight
blinks. This is the third number of the 4 digit setup code.
O Press the 4 key and count the number of times the backlight
blinks. This is the fourth number of the 4 digit setup code.
• The backlight flashes twice immediately after the "0" is input to confirm
input.
• If the backlight does not blink, the first digit in the setup'code is 0.
’ If the backlight does not blink, the second digit in the setup code is 0,
’ If the backlight does not blink, the third digit in the setup code is 0.
’ If the backlight does not blink, the fourth digit in the setup code is 0.
Perform each step within 5 seconds.