Getting the most from your remote controt, Operating other components – Kenwood 1080VR User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting the most from your remote controt
1080VR (En/K)
Keys or controls used in this operation.
Operating other components
■< 2:мгz^..~2.мmsr^z■xyyт>:
*
-»
This operation lets you operate the registered components.
KENWOOD audio components with system control turn on and off automatically with the receiver via the system control
connections.
' Pressing the VIDEO or AUDIO key also changes the input selector on
the receiver. If you do not want to change the current input, press the
SHIFT key before step
O.
-
Jl,
VIDEO
key
® VIDE01 (VCR II
® VIDE02 (VCR 2)
® VIDEOS (LD)
® AV AUX
AUDIO
key
1 CD (CD)
2 TAPE/MD
(TAPE)
J'TUNER
® PHONO
TV
key
T TV1
2 TV2
T CABLE
c
»Pressing the SHIFT key is only required when turning the selected
component on or off. Pressing the POWER key directy turns the
receiver on and off.
• See "Remote operation of other components" at the end of this manual
for a list of keys available with each component.
-i3l
The remote control mode remains in the set at the compo
nent selected in step
O
mode until you select another
component (etc.).
Be sure to point the remote control at the remote sensor on the receiver when you want to operate KENWOOD components connected by
system control cords. Otherwise, point the remote control at the component you want to operate.