Kenwood 1080VR - Manual (Page 19)

1
^ Before listening to an RDS broadcast, follow the instructions
55 below to store the RDS stations in the preset memory.
; Up to 40 stations can be preset, and then receivied with the
' touch of a single button.
This receiver uses the Radio Data System (RDS) to provide
convenient tuning functions like PTY and TP search.
listening to radio broadcasts
108ÛVR (En/K)
Keys or controls used in this operation.
This function automatically stores up to 40 RDS stations in the preset memory. In order to use the TP and PTY functions, the
RDS stations must be stored in the preset memory using the RDS AUTO MEMORY function.
Set the input to tuner.
Frequency display
rm |-7ii"7i
U . J. VJ VJ
Set the broadcast band to "FM".
Store the stations automatically.
Press and hold the "MEMORY"
key for more than 2 seconds.
&
Each press switches the band as follows;
^ ■I'l
I— ,
1 FM
2 AM
"in nn
J „1. VJ VJ
"FM" IS displayed
n I I T n
I N I I I I
l\/I I
I I r
l\/I I I
I I u
Blinks
•After a few minutes, up to 40 RDS stations are preset in order from
channel "OT.
• Stations already stored m the preset memory may be replaced by RDS
stations. (I.e,, If the RDS AUTO MEMORY function finds 15 RDS
stations, the stations currently preset at numbers 01-15 are replaced
by the RDS stations.)
Receiving preset RDS stations
-y n-. ,
Press the numeric keys in the following order:
For "15", press l+10|,
For "20", press [+10], [+1^, [o]
• If you make a mistake entering a two digit number, press the +10 key
several times to return to the original display and start again.
•To change the Information in the display, press the DISPLAY key.
I I
I "I
n I I r/i I 'Ti
G . J. VJ VJ