Casio PV-S6100 - Manual (Page 129)

127
Chapter 12 Data Communication
Notes
•
The above procedures can be used to send or receive all data in specific
modes only. You cannot send or receive individual data items.
• Data communication can be interrupted at any time by pressing Esc.
• If the secret memory area is accessed on a unit receiving data, the received
data is stored in the secret memory area, regardless of the memory area
the data is in on the sending unit.
• Transferring data from the PV-S1600 to a PV-100 or PV-200 causes all
euro symbols to be replaced by spaces.
• The size of the PV-S1600 screen is 160
×
160 dots. Transferring
PV-S1600 Quick-Memo data to a PV-100 or PV-200, which both have
98(V)
×
124(H)-dot screens, causes the right side and bottom part of the
Quick-Memo image to be cut off in order to fit the PV-100/PV-200 screen.
Data Communications Between a PV Unit and
a BN Unit
This section describes how to set up and communicate between a PV Unit and a
BN Unit (BN-10/BN-20 or BN-10A/BN-20A/BN-40A).
• You must purchase a separately available SB-305 serial cable, and SB-90
connector/cable set to connect a PV Unit to a BN Unit.
To connect a BN Unit to your PV Unit
1. Make sure that the power of both units is turned off.
2. Open the cover of the Mini Cradle port of the BN Unit, and connect its
Mini Cradle to the port.
3. Connect the optional SB-305 serial cable to your PV-S1600.