Sharp VIEWCAM VL-NZ50U - Manual (Page 72)

Appendix
Svm|)k)in
PosHibli*
SllCJCjOSlod '-:rilLi1iun
o
ward tape.
iws:::c::ua>cg::::,,t.yo:c:..uc:mpc.
sired point (p. 19).
1
g
>
Video noise in image. Dirty video heads. Call for service (p. 60) or use a com-
merciaily available cleaning tape
(p. 5S).
Old or worn tape. Use a new cassette.
Cassette will not eject. Power source is not properly con­
nected. Connect power source properly
(pp. 7,9)
Battery pack is not charged. Charge battery pack sufficiently
(p.8).
Camcorder is recording. Stop tape and try again (p. 16).
No image on monitor. Backlight has been turned off. Turn on backlight (p. 48).
0
1
Fluorescent lamp has burned out. Call for service (p, 60).
Monitor picture is hard to
see. Inappropriate picture adjustments. Adjust picture (p. 48).
CHARGE indicator
flashes in red when
charging battery pack. AC adapter or battery pack may have
malfunctioned.
Call for service (p. 60).
Cannot edit to connected
VCR. Audio/video cable is not properly
connected. Connect audio/video cable properly
(p. 43).
Notes:
• This unit is equipped with a microprocessor. Its performance could be adversely affected by externa!
eiectricai noise or interference. If this should happen, turn off the power and disconnect the unit from
any power sources, including the lithium battery, etc. Then reconnect the power sources to resume
operation.
• If the characters displayed on the monitor screen appear to malfunction, disconnect the power source
and remove the lithium battery, then reconnect the power source, insert the lithium battery, and turn the
power on again. The characters on the monitor should be norma!. Set the date and time, then resume
operation.
59