Sharp VIEWCAM VL-NZ50U - Manual (Page 61)

Picture/Backlight
Adjustments
If the picture is difficult to see due to ambient
light or other factors, adjust the monitor picture
settings.
• The example screens shown are for CAMERA
mode.
Adjusting the Picture
1 Press the MENU button until the menu
screen appears.
2 Press 7 or A on the operation button
to select LCD, then press the SET button.
3 Press 7 or A to select “LCD BRIGHT”
or “LCD COLOR”, then press the SET
button.
4
Press 7 or A to adjust the item to the
desired setting.
LCD BRIGHT TllllODDa* *:..'
Darker-*^-Brighter
LCD COLOR »illiQ.OOflAtt
Decrease.*^ Increase
Adjusting the Backiight
1 Press the MENU button until the menu
screen appears.
2 Press 7 or A on the operation button
to select LCD, then press the SET button.
3
Press 7 or A to select “BACKLIGHT”,
then press the SET button.
V©
5 Press the SET button, then press the
MENU button to turn off the menu
screen.
Note:
• When adjusting the color, the picture on the LCD
monitor may differ from the picture actually
recorded. Do not change the color setting unless
necessary. (This adjustment only affects the
monitor picture, not the recorded image.)
l i i
tlf. I C O B R I G H T
. . I - I U ) i ; n i P R
T i - R E t U R N © : • : ■
O n K M A I
K K I R H I
U l 1
Press 7 or A to select “AUTO”,
“NORMAL’, “BRIGHT” or “OFF”, then
press the SET button.
IBRIGHT BAC KLIGH T
AUTO: The camcorder automatically
switches between “NORMAL” and
“BRIGHT” depending on the ambient
light. This mode is only available in
CAMERA mode.
NORMAL: For use Indoors or under
moderate lighting conditions,
BRIGHT: For use outdoors under
strong lighting conditions, such as
bright daylight.
OFF: The backlight turns off. To turn it
on again, press the MENU button.
5
Press the MENU button to turn off the
menu screen.
48