Editing with the dv terminal (ieee1394), To record from video equipment, To stop recording – Sharp VIEWCAM VL-NZ50U User Manual

Page 57: Cutting unwanted sequences

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Editing with the DV

Terminal (IEEE1394)

This camcorder enables you to perform digital
video editing. Connect the camcorder to video

equipment with a DV terminal using a commer
cially available DV cable. A DV cable is able to

transfer all dubbing signals including video

and audio.

To Record from Video Equip
ment

Set the camcorder to VCR mode, and

insert a Mini DV cassette.

Begin playback on the video equipment

connected to the camcorder.

• Check the camcorder screen to see it

the picture is properly received.

To Record to Video Equipment 3

See “Cutting Unwanted Sequences” on page

43, using the video equipment as the recording

source.

Note:

• Make sure that the video equipment to which

you are recording can input dubbing signals via

the DV terminal.

Press the REC START/STOP button on

the camcorder.

• The camcorder enters Recording

Standby mode.

Press

on the Operation button to

begin recording.

To stop recording

Press v' on the Operation button.

Cutting Unwanted Sequences

Press

to pause recording when the

source tape reaches the beginning of

the sequence to be cut.

Press

to resume recording when the

source tape reaches the end of the
sequence to be cut.

Notes:

• Make sure that the video equipment from which

you are recording can output dubbing signals
via the DV terminal.

• If the video equipment is not set to playback

mode or the DV cable is not properly connected,

“NO SIGNAL" is displayed on the camcorder

screen.

• If no picture or sound is input to the camcorder

even if the DV cable Is properly connected and
you are playing back the source media from the
video equipment, set the Power switch on the
camcorder to OFF and then back to VCR, or
disconnect the DV cable and connect it again.

• If a digital video recording with a copyright

protection signal is used as the playback source,
“COPYRIGHT PROTECTED." appears on the

camcorder monitor and the recording function is
disabled (see page 51).

• When displaying the playback picture on the

recording equipment, you may find black bands

around the image. This is caused by the
differences of the image display sizes.

• You cannot output the picture playing back from

the DV terminal to an external monitor.