Sharp VIEWCAM VL-NZ50U - Manual (Page 47)

Using the Remote
Control (Not supplied)
The remote control (RRMCG0084TASA) is not
supplied with this camcorder. Contact the
nearest SHARP service center or your dealer
for purchasing as a specified part.
Installing the Batteries
1
Open the battery compartment cover.
2
Insert the two commercially available AA
(R6 or UM/SUM-3) batteries with the
battery poles positioned as indicated.
3
Place the cover.
Activating
1
In VCR mode, press the MENU button
until the menu screen appears.
2
Press 7 or A on the operation button
to select ETC, then press the SET button.
3
Press "7 or A to select “REMOTE”,
then press the SET button.
4
Press V or A to select “ON”, then press
the SET button.
REMOTE ION
5
Press the MENU button to turn off the
menu screen.
Operating
Aim the remote control at the remote sensor of
the camcorder, and press the control buttons to
operate.
REW button
REC START/STOP button
ZOOM buttons (W/T)
FF button
SLOW button
PLAY button
'STOP button
VOLUME -/+ buttons
PAUSE/STILL button
Notes:
• Do not use old and new batteries together or
batteries of different brands together.
• Be careful not to expose the remote sensor to
direct sunlight or strong interior lighting, as this
may prevent the remote control from operating
properly.
• Be sure that there are no obstacles between the
remote control and the remote sensor.
34