Charging the battery pack, Extending battery pack life – Sharp VIEWCAM VL-NZ50U User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Charging the Battery
Pack
1
Attach the battery pack on the
camcorder, and make sure that the
Power switch is set to OFF.
Plug the AC adapter into a power outlet
(i'i)), then insert the DC plug into the DC
input jack ((
2
)).
• The charge indicator lights up.
• The charge indicator turns off when the
battery is charged.
3
Remove the DC plug from the DC input
jack, then remove the AC adapter from
the power outlet.
Charging time and maximum continu
ous recording and playback times
Bslkry
Chririjirii; Max. canliniiiiiis Max. cMinliniimis
iiiiuk
linu
recorttirig tliiteiiilaybiiak tiiMu
Rl '1
2iir
iiii. Suniiii.
liir. aoniiii.
BT-L445
approK.
3hr. aomin.
approx.
3hr.
approx.
3hr.
Notes:
• Charge the battery pack between 50°F and
86°F (10°C and 30°C). The battery pack may
not charge properly at temperatures too low
or too high.
• The battery pack and charger become warm
during charging. This is not a malfunction.
• Using the zoom (see page 17) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease in the actual
recording time compared to the maximum
continuous recording time listed above.
• The charging time and recording time may
vary depending on the ambient temperature
and the condition of the battery pack.
• See page 53 for more information on using the
battery pack.
Caution:
• Charge only SHARP mode! BT-L225 or BT-L445
battery packs. Other types of battery packs may
burst, causing personal injury and damage.
Extending battery pack life
Even when the battery pack is not used, the
capacity of the battery pack will naturally
deteriorate over time. To limit the deterioration
of the capacity, it is recommended to perform
the following procedure at least once every six
months:
CT. Fully charge the battery pack.
(OAttach the battery pack to the camcorder,
and set the Power switch to CAMERA
v/ithout inserting a cassette. Allow the
battery power to fully discharge by leaving
it on the camcorder until the camcorder
power automatically turns off.
ti Remove the battery pack and store it
between 50°F and 58^F (10“C and 20^C).
•
3
1