beautypg.com

Multi-line telephone connections, Iii. electrical connection – Brother FAX-1000 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

To connect your FAX-1000 to the telephone line, follow these steps:

The telephone handset which is included in the carton must be connected to the FAX-

1000 by plugging in the handset cord into the jack on the side of the FAX-1000 unit.

Take the telephone cord which is also included in the carton and connect one of its plugs
to the jack in the back of the FAX-1000 unit and the second plug to your modular wall jack

(RJ11C). Now, the FAX-1000 is connected to the telephone network.

II.

MULTI-LINE TELEPHONE CONNECTIONS

Most offices have key systems or PBXs. While in many cases it is relatively easy to connect the
FAX-1000 to a key system or a PBX, we suggest that you contact the organization which installed

your company's telephone system and ask them to connect the FAX-1000 to the system. If the

FAX-1000 is connected to a multi-line system, ask your installer to connect the FAX-1000 to the
last line on the system. This way, the FAX-1000 will not be activated by every phone call coming

into your office. The preferred solution is to ask the phone company to assign a separate line to

the facsimile unit. In this case, you can leave the unit on 24 hours a day and derive full benefits
from its automatic, unattended operations capabilities.

III. ELECTRICAL CONNECTION

The FAX-1000 can be plugged into any standard power (120 VAC) outlet. Simply make sure that

the outlet is grounded and that it is not on the same line as appliances or office machines which
tend to draw a lot of power in a very short period of time, such as refrigerators, copiers, etc. The

FAX-1000 power requirements are listed in the SPECIFICATIONS.

IV. INSERTING THE RECORDING PAPER ROLL INTO THE UNIT

To insert the paper roll, follow these directions:

1.

Make sure that the POWER Switch is OFF. The switch is located on the back of

the facsimile machine.

2.

Press the OPEN button which is located at the lower left front of the machine.

This opens the cover.

3.

Hold the recording paper roll so that the free end of the paper points towards you

from the top of the roll.

4.

Place the paper roll into the machine* and insert the edge of the recording paper

into the guide slot. Make sure that at least 1-1/2" of paper is fed into the slot.

5.

Push the cover shut until you hear a click.

6.

Turn the power ON.

7.

Press the STOP button located on the right side of the cover for approximately

one (1) second until you see the edge of the paper coming out of the unit.

* This unit accepts two sizes of paper-A4 (8-1/2") and B4 (10.1"). You can move the adjustment
plate to accomodate the appropriate paper size.