beautypg.com

Iii. programing the unit, A. programming the date and time, B. programming your telephone number – Brother FAX-1000 User Manual

Page 13: C. programming your name or other form of an id

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

III.

PROGRAMING THE UNIT

THE FAX-1000 has many capabilities. These can be programmed by the user. The method for
programming these will be described when we address a specific capability. Here, we will adress
eight (8) fundamental operations.

Important: Perform ail programming operations

without a document in the feeder.

A. Programming the date and time
B. Programming your own telephone number
C. Programming your name or other form of ID

D. Header print
E. Selecting the number of rings for the unit to answer a transmission
F. Programming one-touch and speed-dial telephone numbers

G. Turning on the automatic paper cutter
H. Reduction

A.

Programming the date and time

This function is used for JOURNAL, TRANSMITTED DATE, TIME DISPLAY in the ready state and

DELAY TRANSMIT.

I.

Press the MODE key six (6) times. SET UP 2 appears on the display.

2.

Press the START/COPY button three (3) times. TIME appears on the display.

3

Press the # key.

4.

Input the appropriate number using the alphanumeric keypad.

5.

Press # before each entry except after the final entry.

6.

Press* when you are finished.

B .

Programming your telephone number

The telephone number, if programmed, will be printed in the journal and the transmitted data at

receiving terminals.

1.

Press the MODE button six (6) times. SET UP 2 appears on the display.

2.

Press the START/COPY button four (4) times. TEL. NUMBER appears on the

display.

3.

Press#.

4.

Input your telephone number using the alphanumeric keypad. Use "A" for

spaces. You can program up to 20 digits as your telephone number.

5.

Press* when you are finished.

C.

Programming your name or other form of an ID

The ID, if programmed, will appear in the LCD of the receiving terminal.

1

.

2

.

3.
4.

6

.

7.
8

.

9.

Press the MODE key six (6) times. SET UP 2 appears on the display.
Press the START/COPY button five (5) times. The display will say COMMENT.
Press the # and the FINE buttons simultaneously.
Press the MODE button until you see the desired letter. (If the MODE button

is depressed over 2 seconds, letters will appear continuously.)

Press START/COPY to program this letter. Up to 12 letters can be programmed

in the ID.

Press MODE until you see the second desired letter.
Press START/COPY to program this letter.

Continue until you've spelled out the entire name.

Press*when you are finished.