Winding the bobbin (continued), Lower threading – Brother X L 2010 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Lower threading

Winding the bobbin (CONTINUED)

Holding the thread end, de
press the foot controller to
wind the thread.
The machine stops automati
cally when the bobbin is full.

S. Push the shaft to the left.

Remove the full bobbin from
the shaft, and trim the excess

thread.

Tighten

the

clutch

release

knob securely.

Unwind about 4 inches (10

cm( from the bobbin, and

insert

the

bobbin

into

the

bobbin case. Pull the trailing

thread into the slot, down

and to the left until it enters

the delivery eye under the

tension spring.

Holding

the

bobbin

case

latch, insert the bobbin into

the shuttle race. Make sure to
fit the metal finger into the

notch at the top of race.