Brother MFC 7000FC - Manual (Page 13)

.................
M F C S E T U P A N D C 0 N N E C T J O N S
A
10
Press Q] on the keypad for each color, as prompted (for initial setup only)
within 1 minute. The MFC will enter a cleaning qcle for approximately five
minutes. The screen alternately displays CLEANING BLACK and PLEASE
WAIT. The ink dot counter will be set automatically for each color, so the
MFC can warn you with an error message when ink is running low.
Ijoad paper in the cassette, then press I Start | within 1 minute.
When the MFC completes the cleaning cycle, the MFC starts printing the test
sheet.
H Only during initial ink cartridge installation, the screen shows.
PRINT
I t YES
OK?
2.NO
Check the print quality of the test sheet. If it is not good, clean the print head
again, by pressing [T|. Then press |Stort| within 1 minute.
The MFC starts printing Test Sheet No. 2.
12
Adjust the Vertical Alignment by following the instructions printed on the Test
Print page.
WARNING
If ink gets in your eyes, irrigate them with water immediately and consult a
doctor if you are concerned.
o
Caution
■ If you pause more than five minutes while inserting the ink cartridges,
the print head will return to the “home” position and the screen will
alternately display SET CARTOIDGES and PRESS INK MANAGE. Press
[Ink Managementl. then press [T] on the dial pad. The print head moves left to
its replacement position again. Continue to install the ink cartridges.
■ DO NOT remove ink cartridges if you do not need to replace them. If you
do .so, it may reduce the ink quantity and the MFC will not know the
quantity of ink left in the cartridge.
■ DO NOT shake the ink cartridges. If you do so, the ink may spill when you
take off the sealing tape. If ink staias your body or clothing, wash with
soap or detergent immediately.