Pioneer CT-W806DR - Manual (Page 34)

TROUBLESHOOTING
When troubles occur:
When certain troubles occur during use of the cassette deck, the following display (service number) appears on the function display of
the cassette deck. If this occurs, follow the "Remedy" below.
Function display of the cassette deck
Service numbers M3 and LI are displayed on the counter Indicator of Deck I while M4 and L2 are displayed on the counter indicator
of Deck II.
Service No. Status of This Unit Cause Treatment
M3 DECK I is in mecha­
nism operation er­
ror status. DECK I mechanism mal­
function
• Turn power off then on again and press the OPEN/
CLOSE button. If the door does not open or the same
information is displayed, the unit may be in trouble.
• When requesting servicing, please notify us of the ser­
vice number displayed on the FL display of the unit.
M4 DECK II Is in mecha­
nism operation er­
ror status. DECK M mechanism mal­
function
• Turn power off then on again and press the OPEN/
CLOSE button. If the door does not open or the same
information is displayed, the unit may be in trouble.
• When requesting servicing, please notify us of the ser­
vice number displayed on the FL display of the unit.
LI DECK I Is In the door
loading error condi­
tion.
•You loaded the tape up­
side down and attempted
to close the door.
• The door hits an obstacle
and cannot open.
• Load the tape properly.
•
The same information is displayed, the unit may be in
trouble.
When requesting servicing, please notify us of the ser­
vice number displayed on the FL display of the unit.
L2 DECK II Is in the door
loading error condi­
tion.
• You loaded the tape up­
side down and attempted
to close the door.
• The door hits an obstacle
and cannot open.
• Load the tape properly.
•
The same information is displayed, the unit may be in
trouble.
When requesting servicing, please notify us of the ser­
vice number displayed on the FL display of the unit.
D1 Digital input • Optical fiber cable is not
connected (except for UK
model).
• Digital pin-plug cord not
connected (UK model
only).
• CD or MD player is not
turned on.
• Connect the optical fiber cable (Sold separately for Eu­
ropean model).
• Connect digital pin-plug cord (Sold separately).
• Turn on power to CD or MD player.
34
En