Buttonhole, Buttonhole -56 – Kenmore 385.15408 User Manual

Page 52

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION VI. BUTTONHOLE

Buttonhole

(j) Pattern selector:
(2) Presser foot:
(D Thread tension:

(I)

Stitch length:

Sliding buttonhole foot

1 to 5

(0.25 to 1)

To adjust buttonhole stitch density

Set the stitch length dial between 0.25 and 1.0 to adjust
the buttonhole stitch density.

NOTE: Always check a buttonhole on a scrap of fabric to

make sure the adjustment satisfies you.

' Starting to sew

Snap the buttonhole foot ( J) oh the presser foot: hoider.: :
Carefully mark the buttonhole length on the fabric.
Place the fabric under the foot, with .the buttonhole marking
running toward you: ;:;:

; i

Move the slider (A) toward you, so that the red arrow (C) on

the slider aligns with the start mark (B). Lower the presser
foot.

NOTEiThe markings on the slider are engraved in

centimeters.

ill

J5E

Set the stitch selector at |] . Sew forward until you reach the ^

front mark of your buttonhole. Stop sewing at a left stitch.

This manual is related to the following products:

385.15202