Threading the machine – Kenmore 385.15408 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread coming off as
shown.
pn Draw the end of thread around the upper thread guide.
[
2
] While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[
3
] Firmly draw the thread up and from right to left over the
take-up lever then down into the take-up lever eye.
13 Slide the thread behind the needle bar thread guide on
the left.
3 Thread the needle from front to back.
...........
• Drawing up bobbin thread
ni Raise the presser foot. Hold the needle thread lightly
with your left hand.
J
Rotate the handwheel counterclockwise, toward you, for
one complete turn. Bring the bobbin thread up by pulling
the needle thread up.
J
Pull both threads 4” to 6” (10.0 to 15.0 cm) under and
behind the presser foot.