Kenmore 385.162213 - Manual (Page 66)

Button Sewing
® stitch selector: 3
( 2 ) Stitch width: 2 to 6,5
(3) Stitch length: Any
@ Needie thread tension: 2 to 6
(5) Presser foot A: Zigzag foot
(6) Feed dogs: Dropped
1. Drop the feed dogs. Place the button below the zigzag
foot, making sure to align the holes with the horizontal
slot in the foot. Lower the presser foot to hold the button
in place.
2. Determine which stitch width setting matches the
distance between the button holes. The needle must go
safely through each hole when sewing.
Unthread the needie to help you determine the zigzag
width.
3. Thread the needle. Turn the handwheel, so that the
needle is in its leftmost position, and then drop the
needie through the left buttonhole,
4. Press the foot control and sew about 10 stitches,
5. Sew the other row of hoies (if applicable) using the steps
above. Trim excess threads from both sides of the fabric.
Overcasting
CÎ) Stitch selector:
(2) Stitch width:
(3) Stitch length:
0 Needle thread tension:
(5) Presser foot A:
(6) Presser foot C:
0 Brush holder seam guide
3
5 to 6.5
Red zone
3 t o 8
Zigzag foot
Overedge foot
This stitch is useful in garment construction, and in finishing
raw edges of any sewing project
If using the zigzag foot, start overcasting with the leftmost
needie position about 1/8" (0,3 cm) from the raw edge of a
seam. The right tip of the stitch should just clear the seam
edge.
For lightweight fabrics, use the overedge foot, To sew, line
the fabric edge up with the inner side of the brush holder
seam guide®.
54