Kenmore 385.162213 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
o Removing the hook cover plate
0 Hook cover plate release button
(2) Hook cover plate
Slide the hook cover plate release button0 to the right,
and remove the cover plate 0-
® Inserting the bobbin
0
End of thread
@
Notch
(3) Notch
0 Threading diagram
Q] Place a bobbin in the bobbin holder with the thread
running off counterclockwise..
] Guide the thread into notch @on the front side of
the bobbin holder, Draw the thread to the left, sliding it
between the tension spring blades.
¡U Continue to draw the thread lightly until the thread slips
into notch 0 . Pul! out about 6" (15.0 cm) of thread
H Attach the hook cover plate. Check the threading by
referring to the diagram 0shown on the hook cover plate