ALTANA Byko-Test MP0R - Manual (Page 5)

5
1 Switching the instrument ON / OFF
Note: The instrument does not have a specific ON / OFF switch.
Switching the instrument ON
The instrument will switch ON automatically when it is placed on a specimen.
If the instrument is placed on nonferromagnetic or electrically nonconductive material, the display will show the
error note "Er6" and then four horizontal bars instead of a reading.
PLEASE NOTE!
Do not power up the instrument by pressing a finger on the sensor! It may result in erroneous measurements.
Switching the instrument OFF / Auto-Switch-Off
After a certain time, the instrument will switch off automatically (OFF = when instrument’s display is empty)
You can set the period from the last measurement to the automatic OFF from the service mode.
See chapter 13 “Service Menus”, page 26.